OpenMV Cam RT1062 Camera for Machine Vision

The RT1062 ARM Cortex M7 processor running at 600 MHz with 32MBs SDRAM + 1MB of SRAM and 16 MB of program/storage flash. All I/O pins output 3.3V and are 3.3V tolerant. The processor has the following I/O interfaces:

• A high-speed USB-C (480Mbs) interface to computer. OpenMV Cam will appear as a Virtual COM Port and a USB Flash Drive when plugged in
  1.5A current limited
  With EMI Filtering and TVS protection
• A μSD Card socket capable of 25MB/s reads/writes which allows your OpenMV Cam to take pictures and easily pull machine vision assets off of the μSD card.
  With EMI Filtering and TVS protection
• A SPI bus that can run up to 60Mb/s allowing you to easily stream image data off the system to either the LCD Shield or another microcontroller
• An I2C Bus (up to 1Mb/s), CAN Bus (up to 1Mb/s), and an Asynchronous Serial Bus (TX/RX, up to 20Mb/s) for interfacing with other microcontrollers and sensors
• A 12-bit ADC (3.3V Tolerant)
• Three I/O pins for servo control
• One I/O pin for frame sync/triggering (or servo control)
• An onboard RTC which keeps running when the system is in low-power mode (the system draws less than 30uA in low-power mode)
  One I/O pin for low power wake up
  There is also a pin for device power button ON/OFF support
• Interrupts on all I/O pins (there are 14 I/O pins on the board)
  With EMI Filtering and TVS protection
• A user controllable/dimmable RGB LED
• Another RGB LED for Charging, USB Power, VIN Power indication
• 32 MB of external 16-bit SDRAM clocked at 160 MHz for 320 MB/s of bandwidth
• 16 MB of program/storage quad SPI flash clocked at 133 MHz in 4-bit SDR mode for 66 MB/s of bandwidth (read speed)
• A 12-bit X/Y/Z accelerometer (2/4/8g) centered underneath the camera module
• Onboard WiFi (a/b/g/n – 11/54/65 Mb/s) and Bluetooth (v5.1 – BR/EDR/BLE) module with a chip antenna
  Option to use a U.FL antenna instead
• Onboard 10/100 Mb/s Ethernet
  Ethernet Jack with PoE support via an external shield
• Strong Cryptographic Authentication Secure Element support via the SE050C1HQ1A removable camera module system allowing the OpenMV Cam RT1062 to interface with different sensors:
• The OpenMV Cam RT1062 comes with an OV5640 image sensor that is capable of taking 2592×1944 (5MP) images. Most simple algorithms will run about 40 FPS on QVGA (320×240) resolutions and below. If you want to use more specialized lenses with your image sensor you can easily buy and attach them yourselfA LiPo battery connector compatible with 3.7V LiPo batteries commonly sold online for hobbyist robotic applications with battery charging support via USB
• 100 mA Fast Charge Current
• With TVS ProtectionAn ARM 10-pin JTAG Header Compatible with SEGGER J-Link Devices for debugging and programming
• With EMI Filtering and TVS protectionExternal 5V VIN with reverse supply protection
• With TVS Protection